5
Use only recommended chargers and charge your batteries only up
to the specified charging time.
Always check your equipment for damage and replace defects with
original spare parts.
Do not use wet devices, even if they are dry again!
Either have it checked in the robbe service or replace it. Hidden
faults can occur due to wetness, which lead to a functional failure
after a short operating time.
Only the components and accessories recommended by us may be
used.Always use original robbe-Futaba connectors as well as
original robbe-Futaba spare parts.
No changes may be made to the remote control systems.
Routine tests before the start
•
Before switching on the receiver, make sure that the throttle stick
is in stop / idle position.
•
Always switch on the transmitter first, then the receiver.
•
Always switch off the receiver first, then the transmitter.
•
Carry out a range test before starting.
•
Is the correct model memory selected?
•
Perform a function test.
•
Are the batteries sufficiently charged?
•
If in doubt, never drive the model!
model company
•
Never endanger people or animals.
•
Do not operate your model near locks and public shipping.
•
Operate your model only in approved locations.
•
Do not operate your system during thunderstorms.
•
Do not "aim" the transmitter antenna at the model during
operation. The transmitter has the lowest radiation in this
direction. The best is the lateral position of the antenna in relation
to the model.
Insurance
Ground-based models are usually covered by personal liability
insurance.
Check your insurance policy and take out insurance if necessary.
Disclaimer:
Adherence to the assembly and operating instructions as well as
the conditions and methods for installation, operation, use and
maintenance of the model components cannot be monitored by
robbe-Modellsport.
Therefore, we accept no liability whatsoever for losses, damages or
costs arising from or in any way connected with incorrect use and
operation.
To the extent permitted by law, the obligation to pay damages, for
whatever legal reasons, is limited to the invoice value of the robbe
products directly involved in the event causing the damage.
This does not apply if liability must be unlimited due to intent or
gross negligence in accordance with mandatory statutory
provisions.
Assembly instructions harbour tug
FAIRPLAY No. 1199
Please read the safety instructions carefully before building
your model. Always follow the procedures and settings
recommended in the instructions. If you are using remote-
controlled model ships for the first time, we recommend that
you ask an experienced model builder for help.
safety notices
Remote-controlled models are not toys in the usual sense and may
only be used and operated by young people under the age of 14
under the supervision of adults.
Their construction and operation require technical understanding,
careful craftsmanship and safety-conscious behaviour.
Errors or negligence during construction or driving can result in
considerable damage to property or personal injury.
As manufacturers and sellers have no influence on the proper
construction and operation of the models, these risks are expressly
pointed out and any liability is excluded.
Ship's propellers and all moving parts in general
represent a constant risk of injury. Avoid touching
such parts at all costs.
Note that motors and controllers can reach high
temperatures during operation. Avoid touching such
parts at all costs.
Never stay in the danger area of rotating parts with
electric motors with connected drive battery.
Also make sure that no other objects come into contact
with rotating parts!
Follow the instructions of the battery manufacturer.
Overcharging or incorrect charging can cause the
batteries to explode. Make sure the polarity is correct.
Protect your equipment from dust, dirt and moisture. Do not expose
the equipment to excessive heat, cold or vibration.
Remote control operation may only be carried out within the
specified temperature range.
Hint!
In addition to the safety instructions listed here,
all safety instructions for the components used for
the RC removal as well as those used in the
travel drive must also be observed!
1199_Fairplay.indd 5
08.07.16 22:39
