13
English instructions for
robbe EOLO
19 mm dimension as shown in the draw-
ing.
- Press the ball-links on the prepared
pushrods onto the linkage balls on the
outer ring of the swashplate S5004.
Note
: when pressing the ball-links onto the
linkage balls note the position of the raised
marker lug on the links: the lug must
always be on the outside of the joint.
- Slide the swashplate onto the main rotor
shaft and engage the spigot in the
swashplate guide.
- Connect the clevises to the servo output
arms, using a lever length of 11 mm.
(13.5mm - see ammendment)
- Assemble the clamp S5042 and the driver
yoke S5105 using the screws S0028 and
S0029 to produce the swashplate driver.
Slip this assembly on the main rotor shaft
and press the bail-link S5090 onto the
middle ball on the swashplate inner ring.
Caution: the threaded hole in part S5042
must be located above the centre of the
parts.
Stage 4
4 Assembling the rotor head and trans-
verse shaft
