Re-binding the transmitter
This procedure is only necessary after replacing individual components.
Move the throttle stick and trim to the bottom position (motor stopped).
Locate the horizontal trim switch below the right-hand stick unit on the transmit-
ter, press it to the left, and switch the transmitter on. Insert the LiPo flight bat-
tery in the compartment on the helicopter, and connect it. The transmitter screen
flashes, and you will hear a continuous warning beep; this process lasts about
five seconds. Do not move the model or the transmitter during this time.
Once the binding process is complete, the screen window reverts to normal dis-
play status, and the warning beep ceases.
This point is very important:
Do not move the model or the transmitter during the binding process.
Checking the working systems
Before the first flight it is important to set all the trims - except for the throttle trim - to
centre. The throttle stick must be in the "fully back" position (towards you). If the ro-
tor blades turn, adjust the throttle trim until the rotor blades come to a halt.
12
Operating Instructions, ARROW PLUS TRAINER EVOLUTION RTF 2.4 GHz No. S2521
