4
with a cloth soaked in warm water with mild
detergent dissolved in it, and then rinse the soap
off with a damp cloth.
Regular cleaning will prevent a build-up of oils
and foodstuff and keep the machine looking new.
Filter Cleaning:
It is important to clean the air filter regularly to
avoid clogging and overheating the microwave.
To clean the air filter unfasten the mounting
screws and remove filter. Wash with warm soapy
water until unclogged, reinstall and fasten screws.
NOTE:
A Clean filter reminder will display every
30 days. This can be shut off by pressing and
holding the ‘Stop’ button for 5 seconds while in
idle mode.
Splash Shield Cleaning:
The Splash Shield can be removed for cleaning as
follows:
1.
Squeeze the left and right locking tabs inwards,
as shown by the arrows, and then pull the
Splash Shield down and out to remove from the
oven.
2.
Wash shield in warm soapy water. Do not place
in dishwasher. Do not use
cleaning chemicals or sanitiser.
3.
After washing, reinsert Splash Shield by
positioning the rear end back into
its position holes, then raise the front of shield
until front clips lock back into their front
positioning holes.
CAUTION:
Ensure Splash Shield is installed
correctly before operating microwave.
INSTALLATION
IMPORTANT:
DO NOT USE THE MICROWAVE
DOOR HANDLE TO LIFT THE MICROWAVE
OVEN.
Damage to the machine as a result of freight must
be reported to the Freight Company and to the
agent responsible for the dispatch of machine
within 24 hours of receipt. No claims will be
accepted after this period.
Do not under any circumstances attempt to use
a damaged product.
Remove all packaging materials, tape, and any
protective plastic from the machine. Remove any
glue residue from the protective plastic or tape
using citrus cleaner.
Product should be installed at counter height only
(approximately 800- 1100mm). Installing outside
the recommended mounting height could cause
damage to the door hinges and prevent
operation.
Do not position the microwave on top of or
immediately above another appliance.
Place the product on a firm, level surface in the
desired position.
Maintain a clearance of 300mm above the
microwave, note a second microwave of the same
model can be stacked on top as long as a 300mm
clearance can be maintained above the second
microwave.