ROBAND DCP23, Operating Instructions Manual

Page: 7 / 21

Page: 4
OVERVIEW OF INDUCTION
When the magnetic flux created
at the coil passes through the
metal pan placed on the top
plate, eddy currents are
generated.
These eddy currents are then
transformed into heat as they
flow backwards and forwards
through the cooking pan.
INSTALLATION

Remove all the packaging materials and tape, as well as any protective plastic
from the machine. Clean off any glue residue left over from the protective plastic
using methylated spirit.

Place the Dipo Induction unit on a firm, level surface in the required position.
Ensure it is positioned at least 100mm away from the wall and other objects.

Connect the Induction Cooker to standard, single phase, 10 Amp power point.
We recommend that the electrical circuit supplying the power point be protected
by an approved RCD earth leakage device. Ensure no water has splashed on
the plug.

National Standards exist outlining the positioning, spacing and ventilation
requirements when installing new appliances. These Standards should be
consulted and new equipment should be installed accordingly. In any situation
where specifications allow a distance of less than 100mm we would still
recommend that a well-ventilated air gap of not less than 100mm be maintained.
If the machine is near particularly heat-sensitive materials common sense should
be employed in determining sufficient clearance.

Do NOT place the induction cooker in, on or near open flames, flammable liquids
or high temperature surroundings

Place additional signage and/or protection around the machine if a Hazard
Assessment for the installation requires.

Do not attach any other items to this machine, or use contrary to what is
described in this manual.

The use of any accessories not recommended by the manufacturer may cause
injuries.