Accessories
1.One copy of the Operation
Manual
2.Two pieces of anchor ear (except of metal soft pipe)
3.One
copy
of
Installation
templet
4.One
piece
of
battery
in
the
packing
foam
Specific fire hole on the electrode
needle of copper cover blocks
Clean blocks and dredges fire hole
Problem
Ignition
Failure
The burner is
not work
when loosen
the knob
Gas leakage
(gas smell)
Possible Reason
Gas Volve is not open
Air exists in gas pipe
The rubber tube is
twisted or blocked
Electrode needle is dirty
lgnitor malfunction or the electrode
needle in wrong position
Without battery,put battery
oppositely or power insufficiency.
The copper core,copper cover,
burner is in wrong position
The damper adjuster too
big and flame left burner.
Time to press On/Off switch
is too short.
Switch is not closed completely.
The rubber tube is not
connected or cracked.
The damper is not
adjusted correctly.
Burner is blocked
The gas used here is not consonant
with the required in the nameplate.
Gas pressure is unstable,
water in the rubber tube.
Measurement
Turn off the control switch
Then turn on the gas valve
Exhaust the air by igniting repeatedly
Straighten,clean or replaced
the rubber tube
Clean clear
Adjust the electrode needle to burner,
keep the distance4mm
Install the battery collectly
or replace the battery
Install the copper core,copper
cover,burner in right position
Adjust the damper
Keep the switch down 3-5 seconds
then loosen
Turn off the switch
Connect rubber tube or replace it
Adjust damper
Choose the cooktop properly
Get rid of water in the rubber tube
Burning
abnormal
or sounding
noise
Clear away the block
General
Troubleshooting
(Picture for reference only.)
Exclusive Fire-hole of Thermocouple
(Fire-holes are easy to be blocked,
users must clean them regularly)
Copper Fire-hole
Fire
hole
on
copper
cover
specific
fire
hole
for
electrode
needle
1. Maintain gas hob surface: Please clean the surface with wet and neutral detergent
cloth, and then clean with dry cloth; Don’t use steel brush or other rigidity objects.
2.Please
clean
fire
holes(groove)by brush or steel needle regularly, and clean dirty on
gas hob avoiding from back fire. Don’t bath gas hob by water.
3. Please check if the copper cover, copper core and ornamental ring are shift or biasing,
and correct them at the right position in time.
Maintenance
Environmental-protection purpose:
1.Please
deal
with
battery
properly
avoiding
pollution.
2. This
product
use
environmental
and
recyclable
package,
please
deal
with cyclable
materials properly
to
reduce
waste.
3. If maintenance confirms this product can’t be used again, please deal with recyclable
materials properly.
7
8
Gas Hob
Gas Hob
