1
.
Be
sure
the
copper
core,
copper
cover,
copper
base
and
pan
stand
in
right
position.Check
the
switch
first
before
turn
on
the
valve
of
the
gas.(PIC1).
2.IGNITION
METHOD:
Push the switch and turn to 90 degrees anti-clockwise for the
strong fire(PIC2),meanwhile the poop sound of pulse firing can be heard. The full
push should be taken for 3-5 seconds till the flame comes out. Otherwise, the same
operation above should be retaken. In addition, push the switch and turn to 90
degrees anti-clockwise again is the small flame. (PIC 3)
Use
Instruction
REMARKS:
①
The first ignition or that of the first reuse of the gas hob may not work immediately,
because of the air inside the tube.Only repeat the operation will work.
②
Between copper core and copper base, there is some gap, and it may cause flame.
It’s normal action.
3.SWITCH-OFF:Turn the switch to the position clockwise(PIC 1) and the fire will be
switched off.
4. FIREPOWER CONTROL: Operate according to the instruction mark.
picture1
picture2
picture3
5. AIRFLOW CONTROL: The air valve, which is used to control the airflow to make the fire
in the good condition, can be adjusted through the spot nail of air valve adjustment under
the cooktop. By turning it clockwise or anti-clockwise to control, which leads the flame
changes accordingly and confirmed until the flame in steady and normal blue color
condition. ( PIC below). The way of distinguishing the flame status is as follows:
●
Air deficiency: the flame is stretched and takes on yellow or red, the interior and exterior
flame is faintly.
●
Air superabundance: the flame is unstable, about to leave the fire cover or flame
becomes short obviously (sometimes will occur backfire when using manufactured
gas), and color of flame appear cyan.
●
Combustion well: the flame takes on cyanine, no yellow flame or red fire, the interior
and exterior flame is clear.
In flow
Stop block for air door
Stop block for nature gas
Stop block for liquid propane gas
Stop block for manual gas
Air
door
Air
door
In flow
Normal
(Full Combustion)
Yellow
Flame
(
Air
deficiency
)
Floating Flame
(Air superabundant)
4.The size of the borehole should be taken according to the requirement,
and put the
built-in gas hob to match the borehole.
5.If the G1/2
inch
connector
is
used,
please make sure to put the rubber gasket
inside the connector and the leaking test should be taken before use.
6.The
qualified reduction valve
should
be
used
when
the
LPG
is
used
as
the
source
of
the
gas.
7.Assisting pan stand is available for
some
models,
and only can be used for pan of
φ
100mm.
5
6
Gas Hob
Gas Hob
