6
Gas
Hob
Installation Instruction
1.
between the Gas Hob and noncombustible should be not less than 7 cm; The Gas Hob and the above object
should have a height of more than 100cm, If you want to install a Rang Hood, the height of 65-75cm from the
Gas Hob is suitable. (This space is set up according to the installation requirements of the Range Hood).
2. The kitchen cabinet for built-in gas stove should be specially designed for the safety concern. The ventilated
2
borehole should be suitable for the safety requirement and the size should be no less than 100 cm .
3. When the special gas tube is used, one side of the tube should be connected with the gas valve while the
other side connected with the inflow side of gas stove. Please take off the cover on the connection point and put
the tube to cover the red-mark point, and tighten it with the anchor ear. Be sure that the leaking test should be
taken before use.
4. The size of the borehole should be taken according to the requirement, and put the built-in gas stove to match
the borehole.
5. If the G1/2
”
inch connector is used, please make sure to put the rubber gasket inside the connector and the
leaking test should be taken before use.
6. The qualified reduction valve should be used when the LPG is used as the source of the gas.
When the Gas Hob is installed, the distance from the combustibles is not less than 15cm, and the distance
Requirement for hole size
Hoop
Red thread
Hose connector
Rubber hose
Gas inlet of stove
Rubber washer
Metal corrugated pipe
Rubber washer
Front valve
Rubber hose diagram
A schematic diagram of a metal bellows
Min550
820
+
2
0
450
+
2
0
Min50