Robalec SW10000, Operating Instructions Manual, Page: 6 / 16

Page: 3
INSTALLATION

Remove all the packaging materials and tape. Clean off any glue residue left
over from the protective plastic using methylated spirit.

Place the Rice Cooker on a firm, level surface in the required position. Before
connecting the Rice Cooker to the power supply, ensure that all the controls are
in the "OFF" position.

Plug the Rice Cooker into a 10 Amp power point (SW5400 & SW6000) or 15
Amp power point (SW10000). Be sure not to overload the power circuit by
operating too many machines together.

National Standards exist outlining the positioning, spacing and ventilation
requirements when installing new appliances. These Standards should be
consulted and new equipment should be installed accordingly. In any situation
where specifications allow a distance of less than 100mm we would still
recommend that a well-ventilated air gap of not less than 100mm be maintained.
If the machine is near particularly heat-sensitive materials common sense
should be employed in determining sufficient distancing.
OPERATION
The Rice Cooker is controlled by a Cook/Warm switch located on the side of the
machine. A pilot light beside the switch is illuminated when the Rice Cooker is
cooking. When the Rice Cooker has reached the set temperature, the machine
automatically stops cooking and warming begins. The cooking light goes out and
the warming light will turn on. To operate the Rice Cooker, follow the procedure
below.
IMPORTANT
The proper operation of the rice cooker relies on the bowl being in good condition. If
the bowl is dented in any way, poor contact is made between the hot plate and
bowl. This will increase the cooking time and can cause serious damage to the
machine.
Be careful when handling the bowl as to prevent dings and
scratches.
Note: As soon as power is applied to the rice cooker, the warming function is
enabled. Although this is low power, heat is still generated inside the machine. The
rice cooker should never be left on without the bowl (containing rice) inside
the machine for longer than 5 minutes.

Fill the plastic measuring container provided to the desired level. The plastic
container makes approximately 5 portions of cooked rice, where a portion of rice
is defined as 150ml (water measurement) of raw rice

It is recommended to wash the raw rice in a strainer until the waste water runs
clear (see Cooking Suggestions for more details ) .

Unplug the Rice Cooker power cord from the wall socket and remove the bowl
from the unit. Inspect the condition of the bowl for dents. If dents exist, do not