Roar Quad 15, User Manual

Page: 4 / 28

4
2. Introduction
The Quad15 is an all tube 4 channel guitar amplifier with programmable effect loops, outputting 15 watts to a speaker
cabinet (not included). The output power to the speaker can be attenuated by the built-in power attenuator to retain
the desired amount of power tube overdrive:
”The Sound of Loud at All Levels”
Channel selection, Input (Front/Rear) and Effect loop (Return/Mix/Dry) can be programmed using a MIDI
footcontroller (not included) or other MIDI device, see page 7 and 15. (
M
usical
I
nstrument
D
igital
I
nterface)
The knobs and switches for each channel are not programmable.
This manual describes all functions in detail. Further information is available at
www.roaramps.com to find soundclips
and instructional videos.
2.1 F
RONT PANEL
2.2 R
EAR PANEL
3. AC
INPUT
& AC
OUTLETS
(M
AINS
)
Power up other devices via
the triple mains outlets of the
Quad15; such as effect units
and power amplifiers. Switch
everything on and off with
the mains switch on the front
panel.
The “Mains fuse” might blow
if a device powered from the
Quad15 fails.
The “Quad15 fuse” will only
blow if the Quad15 fails.
The Quad15 is equipped
with a standard IEC mains
inlet with surge protection
filter and is fused by both
the “Mains fuse” and the
“Quad15 fuse”.
For world wide use, the
Quad15 is equipped with a
voltage selector to set the
mains voltage level to 230V
or 115V. Note that there's
no need to replace any
fuses dependent on the
mains voltage!