Roadtrek Inc.
30
Outside Your Roadtrek
Awning
Your Roadtrek is equipped with an easy to use power roll up awning.
Please read the awning manual before you start. You need to know how the supports are attached
and how to secure the awning. The steps here are meant as an indication of what is needed.
To use the awning please follow these steps:
•
Check for tree branches and other obstructions.
•
Press the switch inside the passenger side front door, above the doorframe to extend the awning
and lower the supports on each side. (Picture 30.1)
•
Once extended, secure the supports to the two attachment points on the side of the vehicle or to the
ground with the pins provided. (Picture 30.2)
To stow the awning:
•
Detach the supports from the attachment points
•
Retract the awning using the power switch
Refer to the awning manual for proper methods of deploying and securing the awning.
The awning is only powered when the ignition switch is off. To use the awning, turn off the ignition.
Never leave your awning extended when you are away from your vehicle as awnings are
susceptible to damage from heavy rain and wind. Stow the awning when bad weather is
approaching.
Picture 30.1
Awning switch above front passenger
seat
Picture 30.2
Awning support attachment point
If the power to the vehicle is not available, the awning can be safely retracted using the manual override
located on the idler (right) end of the case. (Picture 30.4)
This procedure cannot be used to extend the awning.
1. Remove the plug from the right end cap and save.
2. Insert a 3/8” socket drive extension and handle into the square drive hole inside the endcap.
3. Turn the handle clockwise until the awning is retracted.
4. Replace the plug.
After closing the awning with the manual override, the lead rail may move out from the case 1/4"-1/2”.
This is normal and the awning is secure for travel until the power is restored or repairs are completed. Do
not attempt to force the lead rail in with the override, serious damage can occur to the awning.
