WATER SYSTEMS
D
Do
occ N
No
o::
21906540-RSAD
R
Re
ev
v::
01
C
Co
op
py
yrriig
gh
htt ©
© H
Ha
an
nm
ma
arr M
Mo
otto
orr C
Co
orrp
po
orra
attiio
on
n 2
20
00
06
6
G
G--3
3
The fresh water tank can also be filled through the city water
inlet located behind the rear lockable driver side access
door, (see Picture G-P5). The use of the city fill is not possible
when the fresh water system has been winterized.
To fill the fresh water tank:
1.
Prior to using city fill, ensure that the fresh water
system is in summer use mode, and has been
de-winterized and the fresh water system has been
sanitized, (see Picture G-P1 on page G-1). Connect
a hose to the city water inlet connection. Remove
the orange gravity fill plug for added venting of
the fresh water tank, (see Picture G-P4).
2.
To fill the fresh water tank, open the city fresh
water tank fill shut off valve, (see Picture G-P6).
3.
Open the water source moderately.
4.
When the tank is full, water will overflow in
the same manner as when using the gravity fill,
(see previous page).
5.
Close the city fresh water tank fill shut off valve,
(see Picture G-P7).
CITY WATER CONNECTION:
NOTE:
City water connection can only be used in summer
operation mode.
The city fresh water inlet connection is located in the small
compartment behind the driver side rear access door,
(see Picture G-P5). To connect the water system to an
outside source:
1.
Ensure that the water pump is turned off.
2.
Close the city fresh water tank fill valve by turning
the handle to the vertical position, (see Picture G-
P7).
3.
Be sure that all interior faucet's are closed to
prevent spillage.
4.
Open the city water source slowly to prevent
excessive water force inside your vehicle. To
protect your system from excessive pressure from
water supply systems encountered in some areas, a
water pressure regulator should be used. Such a
regulator is not supplied with your vehicle.
5.
Note that this connection by-passes the water pump
and fresh water tank. Therefore, the use of these
items is not necessary when connected directly to an
external water source.
Picture G-P6:
Open position of the city fresh water
tank fill valve.
Picture G-P7:
Closed position of the city fresh water
tank fill valve.
Picture G-P5:
Location of the city fresh water inlet
connection.
