45
© Erwin Hymer Group North America, Inc., R00
Outside Your Roadtrek Continued:
Shore Power
The shore power connection is through the shore power cord, stored in the rear of the coach under the sofa. (Picture 45.1)
The shore power connect port is located underneath the second running board on the driver’s side right in front of the rear axle. Notice that one
terminal has a slight bend to it. (Picture 45.2)
Match up slightly bent terminal on connect port with slightly bent terminal on 30AMP shore power cord. (Picture 45.3) After lining up the terminals,
gently push the cord until the prongs are completely seeded and turn the power cord slightly to the right. Proceed to take the black plastic
threaded ring and line up with threads on connect port. Turn clockwise to tighten and secure the power cord to the connect port. When connected
and plugged into a power source, the red light on the power cord will illuminate.
The switchover from shore power to inverter is automatic. Before plugging in, turn on the coach inverter switch located next to monitor panel. To
connect to external (shore) power, plug your power cord into a 30AMP power source. At this point your inverter will recognize the power source.
If a true 30AMP power source is not available, adapters are available that allow for plugging into 110-Volt outlets.
See HOWTO’s: Shore power for a concise guide on how to connect and disconnect to shore power.
30AMP Power Cord.
(*Note – The Bend
in the Terminal with Blue Arrow. Attach
to Terminal in Picture 45.2.)
30AMP Connect Port.
(*Note – Bottom Terminal with Slight
Bend.)
30AMP Power Cord Stored in Rear of
Coach.
Picture 45.1
Picture 45.2
Picture 45.3
