DAILY LIVING
Doc No:
21906532
Rev: 07
Copyright © Roadtrek Motorhomes Inc. 2010
B - 13
WASHROOM FACILITIES:
TOILET:
1. Privacy is achieved by closing the Permanent Bathroom door.
STAND-UP AISLE SHOWER:
To set up the stand-up aisle shower:
1.
Remove floor drain cover from floor and loosen the
drain plug/strainer, (see Picture P-B29).
2.
Privacy is achieved by extending the bathroom
door and closing the galley, side door, and
windshield curtains.
3.
Release the Velcro retention straps from the shower
curtain and move the hand held shower from its
storage position to the shower position,
(see Picture B-P30).
4.
Draw the shower curtain until you are completely
surrounded.
5.
Using the Velcro connectors, secure the edges of
the curtain to the inside edges of the door.
6.
When adjusting the water temperature, be sure to
allow enough time for the temperature adjusted
water to exit the shower head before making
further adjustments.
7.
Roof vent or the bathroom vent may be used on
low
speed
to remove steam and moisture.
To put away the stand-up shower:
1.
Rinse and dry the shower curtain thoroughly,
(this function is most easily performed before
leaving the shower area after use).
2.
Allow the curtain to air dry completely, (this
function can be expedited by using the power roof
vent or the power bathroom vent).
3.
Replace drain plug and floor drain cover when you
are finished.
To prevent the grey water tank contents from spilling onto the
floor while driving, keep the drain plug secured when not in use.
Picture B-P30:
Location of the shower head in the
shower position.
Picture B-P29:
Floor drain, to remove the floor drain
cover use the access holes provided in the cover.
Floor Drain Cover
