Roadstar HRA-1245NWD, User Manual

Page: 4 / 28

1 English
LOCATION OF CONTROLS
1. FUNCTION SELECTOR
2. VOLUME KNOB
3. SPEAKER
4. ANTENNA
5. TUNING KNOB
6. DIAL SCALE
7. AUXILIARY INPUT
8. AC CORD
PRECAUTION
•
INSTRUCTIONS - All the safety and operating instructions should be read before the
radio is operated. The manual should be retained for future reference.
•
HEED WARNINGS - All warnings on the appliance and in the operating instructions
should be adhered to.
•
WATER AND MOISTURE
- The appliance should not be used near liquids or in rooms
with a high level of humidity.
•
VENTILATION - The appliance should be situated so that its location or position does
not interfere with its proper ventilation.
•
HEAT - The appliance should be situated away from heat sources such as radiators,
stoves or other appliances that produce heat.
•
POWER SOURCE
- The radio should be connected to power supply only of the type
described in the operating instructions or as marked on the appliance.
•
POWER CORD PROTECTION - Power supply cords should be routed so that they are
not likely to be walked on or pinched by items placed upon/against them.
•
OBJECT AND LIQUID ENTRY - Care should be taken so that objects do not fall and
liquids are not spilled into the enclosure through openings.
•
SERVICING - The user should not attempt to service the appliance beyond that descri-
ve in the user operating instructions. All the servicing should be referred to qualified
service personnel
Note: If the display does not function properly or no reaction to operation of any control may
due to the electrostatic discharge. Switch off and disconnect the AC cord and remove all the
batteries, then turn the power back on after a few seconds.
POWER SOURCES
AC POWER:
To power your radio, plug the AC power cord into into a wall AC power outlet.
Check that the rated voltage of your appliance matches your local voltage.
TO USE THE RADIO
1. Move the [FUNCTION SELECTOR] (1) to the desired;
2. (Please see detailed instructions for each Source in the following chapters);
3. Adjust the volume with the [VOLUME KNOB] (2) to the desired level ;
4. Move the [FUNCTION SELECTOR] (1) to OFF to turn OFF the unit.
RADIO OPERATION
1. Set the [FUNCTION SELECTOR] (1) to “FM” mode;
2. Adjust the frequency to your desired station by using the [TUNING KNOB] (5).
Note: For a better reception, reorient the antenna (4).