KIT# 524448-4
12/5/18
KS
6. On each side, pull back on the top of the fascia to release the clip in the bottom lower corner of the headlight and then
pull down on the fascia, perpendicular to the seam, sliding out the two aligning pins (Fig.I).
7.
For models without a front camera sprayer:
proceed to the next step.
For models equipped with a front camera
sprayer:
disconnect the sprayer hose from the sprayer fitting (Fig.J) and then release all of the clips attaching the sprayer
hose to the fascia (Fig.K). Secure the hose above the reservoir for now.
Note:
it may be necessary to use either a second
person to hold the fascia during this process or prop the fascia after removal.
8. Release the wiring loom from the shock absorption
pad by releasing all the fasteners attaching it to the louver
housing. It will not be replaced.
Note:
retain the shock
absorption pad for replacement in case the bracket is ever
removed from the vehicle.
9. Trim the louver housing to allow clearance for the main
receiver brace (Fig.L — passenger side) (Fig.M — driver's
side).
BASEPLATE KIT
INSTALLATION INSTRUCTIONS
ROADMASTER, Inc. 6110 NE 127th Ave. Vancouver, WA 98682 360-896-0407 fax 360-735-9300 www.roadmasterinc.com
Fig.L
Fig.J
front camera
sprayer fitting
Fig.K
Fig.M
Fig.I
All illustrations and specifications contained herein are based on the latest information available at the time of publication approval.
ROADMASTER, INC. reserves the right to make changes at any time without notice in material, specification and models or to discontinue models.
Summary of Contents for BASEPLATE KIT
Page 9: ...KIT 524448 4 12 5 18 KS...
