RME Audio HDSPe RayDAT, User Manual

Page: 55 / 84

User's Guide HDSPe RayDAT
© RME
55
20.7.2 MIDI Page
The MIDI page has four independent settings for up to four MIDI remote controls, using CC
commands or the Mackie Control protocol.
Index
Select one of four settings pages and thus remote controls. Settings are remembered automati-
cally. To activate or deactivate any of the four r
emote controls check or uncheck ‘In Use’.
MIDI Remote Control

MIDI In. Input where TotalMix receives MIDI Remote data.

MIDI Out. Output where TotalMix sends MIDI Remote data.

Disable MIDI in background. Deactivates MIDI Remote Control as soon as another appli-
cation is in the focus, or when TotalMix has been minimized.
Mackie Control Options

Enable Protocol Support. When disa-
bled TM FX will only react on the Control
Change commands of chapter 22.5.

Extender to. Sets the current remote to
be an extender to the main remote. Both
remotes will be shown as one block and
navigate simultaneously.

Map Stereo to 2 Mono Channels. One
fader controls one (mono) channel.
Should be disabled when stereo chan-
nels are used.

Submix Selection in Input/Playback
Row.
Enables a selection of the submix
when in first row, without having to
change to the third row first. However,
when using both mono and stereo
channels first and third row usually do
not match anymore, so the selection of-
ten becomes unclear this way.

Enable full LCD support. Activates full
Mackie Control LCD support with eight
channel names and eight volume/pan
values.

Send User defined Names. Channel
names defined by the user will be sent
to the remote device via MIDI and
– if
supported
– shown in its display.

Send Level Messages. Activates the
transmission of the level meter data. Peak Hold activates the peak hold function as set up
for the TotalMix level meters in the preferences.
Note: When MIDI Out is set to NONE then TotalMix FX can still be controlled by Mackie Control
MIDI commands, but the 8-channel block is not marked as remote target.