Web Management
The RLH-ESMXXX-XX-X series switch supports Web management.
It is very intuitive to manage and maintain the equipment through Web interface. Before configuring the
switch, please ensure necessary software installed your computer and reasonable configuration of the
network.
The lowest requirement for user's computer is as below:
•
Install operating system (Windows XP/2000,etc)
•
Install Ethernet card
•
Install Web explorer (IE6.0 or higher version)
•
Install and start TCP/IP protocol
Network Setting
The switch’s default address is:
192.168.1.254
, subnet mask is:
255.255.255.0
. When entering into the Web
interface through internet explorer, the IP address of switch and PC must be in the same Local Area Network.
You can modify PC's or the switch's IP address to make sure that they are in the same Local Area Network.
Operating process can follow method 1 or method 2 as below,
Method 1: Modify PC's IP address
•
Set DIP switch 1 to ON. Restart the power of the switch and set DIP switch 1 to OFF. Restore the device to default
settings. (The device's IP address is probably changed, this step can restore devices’ IP address to default
address.)
•
Click Start->Control panel->network connections->Local area Connection->Properties->Internet protocol (TCP/
IP)Setting PC’s IP address: 192.168.1.X (X is less than 254, from 2 to 253).
•
Click “OK”, IP address modifies successfully. The Windows operation interface is shown below:
Configuring the System
18
