2 • 35-3010RKA-08 Sample-Draw Detector
Description
This section describes the components of the
35-3010RKA-08 sample-draw detector
. The
sample-draw detector consists of the housing, flow system, and detection system.
Figure 1: Sample Draw Detector Component Location
Housing
The sample-draw detector’s fiberglass housing is weather- and corrosion-resistant. It is
suitable for installation where general purpose equipment is in use. The housing door is
hinged on the left side and is secured by two latches on the right side.
Four mounting feet are attached to the back of the housing (one at each corner). Use the
Amp 1
Flow Block
for IR CH4
IR CH4
Sensor
Hydrophobic
Filter (AcroPak)
Charcoal Filter
H2S Dummy Sensor
Pump
LEL Transmitter
Exhaust Fitting For 1/4"
OD Rigid Tubing
3/4 Conduit Hub, 2X
Combustible Dummy Sensor
Oxygen Sensor
CO Dummy Sensor
Amp 2
Inlet Fitting For 1/4"
OD Rigid Tubing
Main Circuit Board
Oxygen
Transmitter
Flow
Block
Reset Switch
Preamp
Circuit
Board
