RKC INSTRUMENT CB100L, Initial Setting Manual

Page: 8 / 30

1. TRANSFER TO MODE
2
IMCB10-E1
h Press the SET key to change to the next parameter. Thus, the data in initialization mode is
unlocked.
*In the above figure, the alarm 1 (ALM1) setting value is displayed. However, the parameter to be
displayed varies depending on the specification.
i Keep pressing both the SET and <RST keys for 2 sec to change the instrument to initialization
mode. Thus, the symbol (Cod) for initialize code selection is displayed first.
z The initialization mode can be selected anytime when PV/SV, SV setting, peak hold value, or
over time is displayed.
z If the controller is change to initialization mode, both limit and alarm outputs contact are set to
the open state, and the analog output, to -5
%
.
RST
RST RST
RST SET SET SET SET
SV SV SV SV
PV PV PV PV
ALM2 ALM1
OUT EXCD
RST RST RST RST SET SET SET SET
SV
SV SV
SV
PV PV PV PV
ALM2 ALM1 OUT EXCD
RST RST RST RST
SET SET SET SET
SV
SV SV
SV
PV PV PV PV
ALM2 ALM1 OUT EXCD
Alarm 1 setting value
Alarm 1 setting value
Initialize code selection in
initialization mode
Bright lighting :
Dim lighting :
NOTES