RJL systems QUANTUM III, User Manual, Page: 26 / 29

- 26 -
Setting up the System Preferences on the Q3
In order to be able to communicate via the RF Link, the Q3
must be properly configured. In the preferences form, se-
lect “PC Link” for printing and “9600” for the Serial Port
Speed.
PRINTING REPORTS USING THE RF LINK
Attach the Q3 RF Link to the Serial Port of the Q3
IMPORTANT: Make sure that the Q3 is turned off before
connecting or disconnecting the RF Link unit. Failing to do
so could result in serious damage to one or both devices.
The Q3 portion of the RF Link plugs into the serial port on
the back of the Q3. When the Q3 is turned back on, the
Light at the bottom will turn on to show that it is connected
properly and that it is receiving power. The upper light will
flash briefly whenever it is used to send data back to the
PC.
Preferences form on the Q3, showing
the settings for printing via the PC
This portion of the RF Link connects
to your PC via a USB cable.
Attach the PC half of RF Link to PC
Raise the antenna of the PC RF Link unit and connect it to
your PC with the USB cable (included). Your computer
should automatically detect the RF Link module and pre-
pare it for use, although it may not
appear to actually do
anything. If your computer displays an error message in a
bubble, unplug the RF Link module and plug it back in.
Please note : If you attempt to connect the RF Link to your
PC before installing the software, it will display an error
message every time. The RF Link requires special device
drivers, which are installed with the software.
The PC RF Link unit, which attaches
to your computer with a USB cable.