STEP 13
OPEN BAG D3 INSTALL TWO 5282 ANGLE
BRACKETS TO THE MOTOR MOUNT. NOTE THAT THE
FRONT ONE MOUNTS ON THE OUTSIDE WITH A FLAT
HEAD SCREW FROM THE INSIDE. ATTACH IT TO THE
CHASSIS REAR WITH TWO MORE 1/4” SCREWS AND
TIGHTEN THEM.
STEP 14
INSTALL THE TOP PLATE TO THE MOTOR MOUNT
WITH A 1/4” SCREW . NOTE THAT THE SQUARE CUTOUT IS
CLOSER TO THE MOTOR MOUNT. SLIDE THE AXLE MOUNT
OVER THE END OF THE TOP PLATE AND ATTACH WITH A
1/4” SCREW. ATTACH THE AXLE MOUNT TO THE CHASSIS
WITH AN ANGLE BRACKET AND TWO 1/4” SCREWS. THREAD
THE BALL STUD FROM BAG D6 INTO THE HOLE AT THE
FRONT OF THE TOP PLATE.
STEP 15
ATTACH THE TWO BODY POSTS FROM D5 TO THE
HOLES JUST IN FRONT OF THE MOTOR MOUNTS WITH 3/8
SCREWS. THREAD THE ADJUSTER NUTS ONTO THEM. IF
THEY ARE VERY TIGHT, USE A DROP OF LIGHT OIL.
STEP 16
OPEN BAG D4. AT-
TACH THE 5581 GEAR TO
THE 5312 HUB WITH TWO
STEP 17
PRESS A BUSHING INTO THE OUTSIDE
OF THE MOTOR AND AXLE MOUNTS. ATTACH THE
HUB/GEAR ASSY TO ONE END OF THE AXLE WITH
TWO SET SCREWS AND TIGHTEN LIGHTLY. RE-
MOVE THE HUB AND GRIND OR FILE FLAT SPOTS
ON THE AXLE FOR THE SET SCREWS TO REST ON.
THIS WILL MAKE IT MUCH MORE SECURE. ADD
THE LONG NYLON SPACER, LUBE THE BUSHINGS
AND SLIDE THE AXLE THROUGH. ADD THE THREE
SMALLER BUSHINGS AND THE 5311 HUB. ADD THE
SET SCREW AND REPEAT THE PROCESS OF ADD
ING FLAT SPOTS ON THE AXLE, THEN RE-INSTALL
THE HUB. ALWAYS TIGHTEN EACH SET SCREW A
LITTLE AT A TIME TO KEEP THE HUB RUNNING
TRUE.
STEP 18
OPEN BAG10. ATTACH THE TWO WING
MOUNTS TO THE TOP PLATE WITH 1/4” CAP
SCREWS. ADD THE OTHER TWO TO THE SIDE OF
THE WING MOUNTS TO RETAIN THE WING WIRE
LATER.
3
