STEP 23
PAINT THE HOOD AND TAIL TANK PARTS AND
THE SIDE PANELS AND TRIM THEM OUT AS SHOWN.
DRILL THE HOLES MARKED WITH A 1/8 “ DRILL TO MOUNT
THEM TO THE CHASSIS. THE TWO HOLES IN THE SIDES
OF THE TAIL TANK SNAP OVER THE TWO SCREWS THAT
HOLD THE REAR OF THE ROLL CAGE TO THE CHASSIS
AND YOU WILL NEED TO REMOVE THE BOTTOM SCREW
THAT HOLDS THE LOWER REAR BAR TO THE 1/2”
SPACER TO ATTACH THE REAR OF THE TAIL TANK.
BEND REAR EDGE UNDER SLIGHTLY
STEP 24
TO MOUNT THE SIDE PANELS, LOOSEN THE
SCREWS THAT HOLD THE FRONT OF THE NERF BARS AND
REMOVE THE SCREWS THAT ATTACH THE CENTER OF
THE ROLL CAGE TO THE CHASSIS. SLIDE THE SIDE PANEL
OVER THE REAR OF THE NERF BAR AND BETWEEN THE
FRONT OF THE NERF BAR AND THE CHASSIS. TIGHTEN
THE FRONT NERF BAR SCREW AND REPLACE THE 1/4”
SCREW TO HOLD THE SIDE PANEL IN PLACE. REPEAT FOR
THE OPPOSITE SIDE. TO INSTALL THE HOOD, SLIDE IT BE-
TWEEN THE CAGE SIDES AND SPREAD IT OUT SO IT WILL
GO OVER THE SIDE PANEL FLANGES. TRIM SLIGHTLY IF
NECESSARY. YOU CAN USE TAPE OR VELCRO TO HOLD
THE REAR OF THE HOOD OVER THE CHASSIS BRACE IF
NEEDED.
DRILL
STEP 25
CUT OUT YOUR WINGS & SIDE DAMS AS
SHOWN ON THE WING DRAWING AND PAINT THEM
AS YOU WISH.DRILL HOLES AS SHOWN IN THE
DRAWINGS. ASSEMBLE THE REAR WING MOUNTS ,
SIDE DAMS, AND BRACES TO THE LARGE WING
WITH SMALL SCREWS AND NUTS PROVIDED.
THERE ARE SEVERAL SETS OF HOLES AT THE
BOTTOM OF THE WING MOUNTS TO MOVE THE LO-
CATION AND ANGLE OF THE WING ON THE CHASSIS.
STEP 26
ASSEMBLE THE SIDE DAMS TO THE FRONT
WING AND CUT OUT THE MOUNT FROM THE LEXAN
SHEET AS SHOWN IN THE WING PARTS DRAWING.
BEND IT AS SHOWN AND USE SERVO TAPE TO AT-
TACH IT TO THE UNDERSIDE OF THE WING AND TO
ATTACH IT TO THE FRONT OF THE HOOD.
5
