TARP DOOR INSTRUCTIONS
Before installing the Tarp Cover (23), install the Tarp Door (21) and Tarp Back
Panel (22). The Tarp Door Panel (21) has two zippers in it.
1. At the doorway of the frame, remove the Bolts (14) and Nuts (16) from the three Top
Rails (1), top and sides.
2.
Place the Tarp Door (21) over the arch of the front End Bow and wrap the material
around the arch while bringing the slits to the inside of the frame. Place the Top Rail (1)
at the Top Crest (12) into the slit.
See Figure 9.
3.
Once the Top Rails (1) are into the slits on the sides and top, put the Bolts (14) and Nuts
(16) back into all the places that they were removed from and tighten them down.
See
Figure 9.
Figure 9
4. Notice the black rope hanging out of the bottom of the Tarp Door (21) on both sides.
With two people, wrap the rope under the Corner Feet (4). Both of you are to pull up at
the same time to tighten the door. When Tarp Door is snug, tie off the rope to the Corner
Feet (4).
5. Attach the side of the Tarp Door (21) to the frame by using the 6 pcs. Ball Tie Downs
(24).
6.
A pipe (not included, 1-1 /4” diameter) can be placed in the pocket at the bottom of each
door. This will keep the door straight and it may roll up easier.
Caution must be
exercised, using the pipe will make the door heavier.
7. At the back doorway of the frame, remove the Bolts (14) and Nuts (16) from the three
End Top Rails (11), top and sides.
SKU 103-1642
Page9
Summary of Contents for RV SHELTER 103-1642
Page 15: ......
