6
Owner’s manual |
Remedy II
adjustable bed
Installation guide
Setting up your adjustable bed
NOTE:
For safety reasons, lifting of the adjustable bed must always be performed by two (2) people; and
the unit should always be on a flat surface before opening.
Lift the adjustable bed out of the shipping carton carefully, and put it on a flat floor
with the top side facing downward.
Remove all accessory boxes and cut the orange ties from inside the adjustable bed.
1
2
3
4
5
1
2
Lift the two separate sections of the adjustable bed out of the shipping carton
carefully, and put them on a flat floor with the top side facing downward.
Remove all accessory boxes and cut the orange ties from inside the adjustable bed.
Move the head and foot sections of the bed together. Make sure the bars and
frames are properly aligned at the center.
To connect the head and foot sections, put the center connection bracket over one
end of the parallel bars between the head and foot sections. Line it up with the pre-
drilled holes on the bars.
Thread the screw through the center connection bracket and into the bars to keep
it in place.
Thread a nut at the end of the screw, and tighten it with the wrench.
Repeat steps 4 to 6 to place the second center connection bracket on the other
end of the parallel bars.
7
6
FOR QUEEN, KING, AND CAL KING MODELS
FOR TWIN, TWIN XL, FULL, FULL XL, AND SPLIT CAL KING MODELS