Rasa Beta Operating Manual
e. In case of partial refueling, the refueling sequence can be interrupted at any time by
pressing the red ”Stop cycle” button (Figure 19).
Always follow the instructions on
the screen before removing the nozzle.
f.
Refuelling takes no longer than five minutes.
11. Disconnect the HRS nozzle
by pulling the outer sleeve of the nozzle towards you (a brief hiss
will be audible, which is caused by gas purging from the fill lines). Lift the nozzle away from
the Rasa Beta refueling receptacle. Return the nozzle to the dispenser.
12. Remove the green earthing connection
and return it to the dispenser.
13. Replace the dust cap on the Rasa Beta and close the fuel hatch
.
14. Drive away.
6. Maintaining the Rasa Beta
The Rasa Beta is a Riversimple asset and is not to be maintained by the user due to the hazards and
specialised skills involved. The only tasks which are permitted to be performed by users is inflation of
the tyres and topping up the washer fluid. Even these tasks need to be performed with special care.
If in doubt please contact Riversimple.
6.1 Tyre Inflation
Tyre Pressures:
Front – 38 Psi (2.62 Bar)
Rear – 38 Psi (2.62 Bar)
Note – due to the rear wheel spats it may not be possible to access the inflation nozzle unless it is
below the base of the spat. Contact Riversimple if these tyres require inflation.
Do not attempt to jack the Rasa Beta or remove the wheels. In the event a tyre needs repair or
replacement contact Riversimple.
6.2
Topping up the washer fluid
To top up the washer fluid the bonnet will need to be removed according to the following sequence:
1. Open both doors and release the 2-stage clips on each side (see Figures 22 and 23). The
inner catch must be released first, then pull the outer catch towards you.
15
