Check for parts online at
www.HuntRiversEdge.com
or call 800-450-EDGE (3343) M-F 8-5
6
Operator's Manual
Hang-On Stands
ASSEMBLY INSTRUCTIONS
(RE552)
Tools needed – two 7/16" wrenches, two 1/2" wrenches
IMPORTANT ASSEMBLY TIP: Do not tighten any nut and bolt combina-
tions completely until all parts are assembled together! Finger tighten
plus one turn of a wrench only! This will temporarily hold the lock nut on
the bolt while helping alignment of all parts! After all parts are assembled
together, all nut and bolt combinations must be completely tightened.
1. Attach the seat frame weldment (CXR15) to the seat post (CXR14) using
(2) provided 1/4-20 x 2-1/2” bolts, locknuts and (6 to 8) nylon washers.
SEE FIGURE 3. DO NOT tighten all nuts and bolts completely!
NOTE: You may need to place 2 nylon washers between seat post
upright and seat frame to take up necessary gap.
2. Attach cable (48212) ends to the platform (CXR12) using (2) provided
5/16-18 x 1-1/2” bolts, locknuts and steel washers.
SEE FIGURE 4.
You must now tighten all nut & bolt assemblies securely. Be sure
not to over tighten or crush tubing when tightening!
NOTE: Using powder graphite lubricant during assembly of moving
parts will help eliminate noise during use!
3. If included, attach backpacking straps (48067) at desired location
on platform. Fold strap in half. Feed folded strap through platform
mesh. Feed the two loose ends of strap through folded loop and pull
tight forming a cinch knot.
SEE FIGURES 5A AND 5B.
Feed straps
through platform mesh and secure with provided tri-slide buckles.
SEE FIGURES 5C
4. Attach padded seat (48103) by feeding straps around the lower portion of
seat frame. Feed the long strap through both metal tri-slides that are sewn
to opposite side of strap. Wrap the long strap back around one tri-slide
and through the second tri-slide and pull tight.
SEE FIGURE 6.
Repeat
the same operation for the other seat strap. Adjust as needed to achieve
desirable seat height. Excess strap can be tucked away using provided
Velcro tabs under the seat.
5. Attach (2) provided 9" camo arm pads (48736) to upper portion of
seat frame weldment by wrapping around tubing and attaching
Velcro together.
FIGURE 6
FRONT VIEW OF
SEAT ASSEMBLY
pull to
tighten
FIGURE 5A
FIGURE 5B
FIGURE 5C
platform cable
5/16-18 x 1-1/2" bolts
steel washers
locknuts
FIGURE 4
locknuts
nylon washers
nylon washers
(2 if needed)
1/4-20 x 2-1/2"
bolts
nylon washers
FIGURE 3
