ASSEMBLE FRONT PANEL
10
BOTTOM PLATE
1854mm
1854mm
TOP PLATE
SELECT:
3 x 1.890 Wall Sheets
1 x 2.520 Top Plate (Red)
1 x 2.520 Bottom Plate (Green)
2 x 1.890 Door Jamb Flashings
40 x 30mm Galv Clouts
19 x Rivets
STEP 1:
•
Lay out 1 x Top Plate and 1 x Bottom Plate on a flat
surface as shown
STEP 2:
•
Using 2 x 30mm clouts, nail the Door Jamb Flashing flush with
the top of the Top Plate at the correct measurement as shown
in plan view. Pre drill holes using a 3.5mm drill bit
•
Check the distance between the top and bottom plates then use
a further 2 x 30mm clouts to nail the Door Jamb Flashings to
the bottom Plate. Pre drill holes.
STEP 4:
•
Place the door on the panel (In open position, approx
20mm below top of top plate). Using two rivets, rivet the top
and bottom hinges to the Door Jamb Flashing, ensuring
door closes properly.
•
Fit remaining rivets.
STEP 3:
•
Place 3 x Wall Sheets on timber, ensuring wall sheets fit un-
derneath door jamb flashings.
•
Ensure that the top of the sheets are flush with the top of the
Top Plate and that the sides of the wall sheets overhang the
Top Plate by
15mm
as shown. Nail wall sheets to Top Plate
(two clouts per pan)
•
Nail the wall sheets to the Bottom Plate making sure that the
Plates are the correct distance apart and that the sides of the
wall sheets overhang the Bottom Plate by
15mm
.
•
Drill & rivet Door Jamb Flashings to wall sheets using four
rivets equally spaced on each side.
NOTE:
The
Doorway is standard at 530mm from left
-
hand end.
To shift the doorway to the right
-
hand side of the front
wall, simply measure 530mm from the right
-
hand end.
NOTE:
Door can be hinged on either side.
IMPORTANT—IF YOU CHOOSE TO RAISE YOUR TIMBER
BASE PLATE –READ THE FOLLOWING;
For sheds with Raised Base Plate option only (see page 6), deduct
30mm from measurement shown between Top and Bottom Plates on
all wall panels, so cladding protrudes 20mm below bottom plate
.
TOP PLATE
TOP PLATE
15mm
15mm
15mm
15mm
530mm
960mm
TOP PLATE
DOOR OPENING
x3
x3
x3
Plan View
TOP
PLATE
DOOR
JAMB
NAIL
