ASSEMBLE FRONT PANEL
10
SELECT:
1 x 1.020 Top Plate (Red)
1 x 1.020 Bottom Plate (Green)
2 x 1.980 Corner Door Jamb Flashing
4 x 30mm Galv Clouts
9 x Rivets
2 x Angle Braces
IMPORTANT—IF YOU CHOOSE TO RAISE YOUR TIMBER
BASE PLATE –READ THE FOLLOWING;
For sheds with Raised Base Plate option only (see page 6), deduct
30mm from measurement shown between Top and Bottom Plates on
all wall panels, so cladding protrudes 20mm below bottom plate
.
STEP 4:
•
Place the door on the panel (In open position,
approx 20mm below top of top plate). Using
two rivets, rivet the top and bottom hinges to
the Door Jamb Flashing, ensuring door clos-
es properly.
•
Fit remaining rivets.
1948mm
1948mm
BOTTOM PLATE
TOP PLATE
STEP 1:
•
Lay out 1 x Top Plate and 1 x Bottom Plate
on a flat surface as shown.
STEP 3:
•
Using 2 x 30mm clouts, nail the Door Jamb
Flashing flush with the top of the Top Plate at
the correct measurement as shown in plan
view. Pre drill holes using a 3.5mm drill bit.
•
Check the distance between the top and bot-
tom plates then use a further 2 x 30mm clouts
to nail the Door Jamb Flashings to the bottom
Plate. Pre drill holes.
•
Check that the frame is square and rivet angle
brace to door jamb as shown.
NOTE:
Door can be hinged on either side.
960mm
TOP PLATE
DOOR OPENING
15mm
15mm
STEP 2:
•
Lay out angle braces at each end of Top
Plate as shown, and using four 30mm clouts,
nail to Top plate at each end.
Rivet
DOOR
JAMB
NAIL
Plan View
TOP PLATE
x3
x3
x3
Summary of Contents for Duratuf Garrison Sheds PL36
Page 1: ...ASSEMBLY INSTRUCTIONS PL36 BASE SIZE 1 020m x 2 020m...
Page 2: ...CHECK OUT OUR ASSEMBLY VIDEO...
Page 15: ......
