Fountain Components
Image
Item Description
Component
Item #
Quantity
Salinas
Fountain,Tall -
Water Feature
FT-383A
1
Salinas Pebble
Fountain, Low -
Basin
FT-381B
1
FT-382 Salinas Fountain, Low
Assembly Instructions
rev 8/18/21
Fountain Information:
• This fountain holds approximately
3 gallon of water.
• This fountain uses a small fountain cover: FTNCOV-SM
• No refill device or submersible lights are suggested for this fountain.
Pump Information:
OEMPF140 - 140 GPH Pump (6 ft. cord length)
Tools Required:
Bubble Level
Screwdriver
Pump Kit Parts List
Image
Component
Quantity
PK140 Pump
(use only large adapter)
1
#10 Stopper
1
Approx. 15" length of 1/2" black
non-kink tubing
1
Approx. 1.5" length of 5/8" clear vinyl
tubing
1
Approx. 1.5" length of 1/2" CPVC pipe
1
Hose Clamps
1
Fountain Set-Up:
Assembly & Installation -
A fountain can be difficult to install without knowing and understanding the steps involved. To ensure your fountain is
installed properly, please read our instructions and tips before you begin.
Step 1 - Seek Professional Help:
Check if professional installation is recommended for your fountain.
Step 2 - Check Foundation:
Place your fountain on a level surface. It is recommended to place your fountain on concrete or a hard packed
gravel pad. If the base is level but some components seem off, rotate components or use wedges to level them.
Step 3 - Create a Drip Loop:
To prevent water from dripping down the cord and damaging the electrical socket, create a drip loop by allowing
the pump power cord to fall below the wall outlet.
Step 4 - Use a GFCI Outlet:
Use only a GFCI outlet when running a fountain.
Proudly
MADE IN USA
