52 | Replacing 9600 Components
Replacing fans
5. Replace the memory module with an approved memory module of the same size.
Note:
Replacing the existing memory module with a module of a different size causes the appliance to fail. You must
use approved memory modules. Contact Riverbed Support at
https://support.riverbed.com
to obtain the correct
memory modules.
6. Align the memory-module edge connector with the slot alignment keys and insert it into the slot.
The module slot has two alignment keys that allow you to install the module in only one direction.
Figure 3-12. Inserting the memory modules into the connector slot and securing
7. Press down on the memory module with your thumbs (see
, letter C and B) while pulling
up on the ejectors with your index fingers (see
, letter A and D) to lock the module into
the slot (see
, letter E).
8. Ensure that all ejector tabs are in the upright locked position.
9. Replace the chassis cover.
10. Replace the power cords and peripherals.
11. Power on the appliance.
Replacing fans
This section describes how to identify fan status and replace fans in the IC 9600 appliances. The section
includes these procedures:
•
“Determining fan status” on page 52
•
“Replacing fans in 2U appliances” on page 53
You must power down appliances prior to replacing fans.
Determining fan status
This section describes how to determine the status of individual fans in the appliance.
