-6-
-7-
NOTE:
Never turn on the fryer with an empty Oil Reservoir. Always use
your fryer on a flat, heat resistant surface.
1. Attach magnetic end of Break-away cord assembly directly to the
fryer (See figure 1). This should be done
prior to plugging the cord into the wall outlet.
The magnetic end of the cord is
designed to only go on one way. Be
sure the side stating "THIS SIDE UP" is
facing up.
2. Remove lid.
3. Remove Frying Basket, pull Basket
Handle up until it clicks into the
horizontal position (Fig. 2).
4. Make sure the Oil Reservoir is seated in
place with the Basket Hook on the side
opposite the Control Panel Assembly.The
Oil Reservoir is also marked indicating
which side is the “Heater Side”. Pour
cooking oil into Oil Reservoir until it
reaches between
“MIN”
and
“MAX”
marks inside reservoir.
DO NOT OVER OR
UNDER FILL.
5. Smear a little oil on the inside of the
Viewing Window.This prevents
condensation, which impedes the view.
6. Place lid onto the unit.
7. Make sure that fryer is off and insert plug into 120 volts AC outlet.
(See “How to use the Digital Electronic Control Panel”)
8. After oil has been preheated, remove lid and place Frying Basket
onto Basket Hook inside Oil Reservoir.
CAUTION:
Keep the Folding Handle in the locked position.
USING YOUR ELECTRIC DEEP FRYER
9. Place food inside Frying Basket (Do not stack food). Place lid back
onto the unit. Lower Frying Basket into Oil Reservoir.
CAUTION:
Always replace lid before immersing food in oil. Do not
immerse or drain food with lid removed.
For cooking times, see fry chart on page 12 or use the recommended
times in your recipe.
10. After time is up, lift Frying Basket and hang basket onto Basket Hook
in Oil Reservoir.To remove excess grease and retain crispness, let
food drain in Frying Basket at least 10-20 seconds. Open lid, then lift
Frying Basket by handle and pour contents onto plate covered with
paper towels before serving.
11. When finished cooking, shut down fryer by pushing the
START / STOP BUTTON.
WARNING: DO NOT USE BREAK-AWAY POWER CORD SYSTEM TO DISCONNECT THE
FRYER. ALWAYS DISCONNECT PLUG FROM WALL OUTLET FIRST TO DISCONNECT
FRYER.
Use only Model# DP16 magnetic cord set with this product. The use of any
other magnetic cord set may cause fire, electric shock, or injury.
CAUTION:
The Break-away power cord is only for accidental
disconnection and is not to be removed during normal operation. If the
cord becomes disconnected, the user should immediately unplug the
cord set from the wall outlet, then reconnect the magnetic cord to the
Deep Fryer.
NOTE:
Your Deep Fryer is provided with a safety protection device:
If the Control Panel Assembly is not properly placed on the Stainless
Steel Exterior, the Control Panel Assembly will not operate.
USING YOUR ELECTRIC DEEP FRYER (CONT.)
Figure 1
Figure 2
CZF600CN.02.CN.OM1 (Visual) 08.10.2002 01.35pm Page 6
