RTS Series
RTS650 Installation Guide
04-2017-A
www.rivatech.de
8
Installation
Note
i
< Use of Ferrite Core >
Installing the ferrite core to a LAN cable is highly recommended to reduce high
frequency noise level. Please follow the instructions below.
1. Open the ferrite core by lifting the clip.
2. Make one loop with the cable through the ferrite core.
3. Close the ferrite core to hold the cable loop into its
place.
Caution
!
Sealing gaps is recommended as gaps may appear after the camera installation.
Gaps may cause problems such as moisture, water leakage and etc., which
negatively affect the operation of the camera if gaps remain unsealed.
Caution
!
To prevent products from damage, place the camera on a stable and non-
vibrating surface. If the stability is in doubt, consult safety personnel for
reinforcements, and then proceed with the installation.
Torx Wrench
Screw &
Plastic Anchor-3pcs
Quick Installation Guide
Installation Template
Adaptor & AC Plug
WALL CUSHION
CABEL CORE
1)
Drill three holes on the installation surface based on the provided installation template.
2)
Insert the plastic anchors into the holes.
3)
Install the provided ferrite core on the cable by referring to the
Note
below.
4)
Attach the provided wall cushion to the bottom of the camera’s pan/tilt bracket.
5)
Fix the camera to the installation surface.
A.
Align the screw holes of the camera’s pan/tilt bracket and the plastic anchors.
B.
Insert the provided screws(M4X35) into the plastic anchors through the screw holes of
the camera’s pan/tilt bracket.
C.
Tighten the screws firmly into the plastic anchors.
6)
Connect all the necessary cables by referring to
5.CONNECTIONS
for more information.
7)
Adjust the angle by referring to
4.2. Adjust angle of the camera
.
DO
DI
1
1
C
C
+
DC12V
ETHERNET
RESET
MICRO
SD
DO
DI
1
1
C
C
+
DC12V
ETHERNET
RESET
MICRO
SD
ETHERNET
WIRE
