Hydro-Air Components, Inc., manufacturer of the
Rittling product line, guarantees their products to
be free from defects in material and workmanship
for a period of one year from date of shipment
from our Buffalo, New York factory.
Should there be any defects in the good(s), the
purchaser should promptly notify Hydro-Air
Components, Inc. and upon receipt of written
consent from Hydro-Air Components, Inc., the
purchaser shall return the defective good(s) to
the factory for inspection with freight prepaid. If
inspection shows the goods to be defective,
Hydro-Air Components, Inc. will at its discretion
repair or replace the said item(s).
Defects arising from damage due to shipment,
improper installation, negligence or misuse by
others are not covered by this warranty.
This warranty is extended only to the original
purchaser from Hydro-Air Components, Inc.
WARRANTY
100 Rittling Blvd. • Buffalo, NY 14220
Phone: 716-827-6510 • Fax: 716-827-6523
Toll-Free: 800-FIN-TUBE (800-346-8823)
E-mail: [email protected] • www.Rittling.com
Revised 0209
(ANG BKT)
(FIN BKT)
PED-SM
The PED-SM floor post is typically used to mount
PR or PRF radiators. Also, PR2F and PR3F radiators
over four tubes tall must also be mounted on PED-
SM floor posts. The ANG BKT (PR & PR2F) or
FIN BKT (PRF & PR3F) wall mounting brackets
supplied with the radiator are bolted to the floor
post, using nuts and bolts supplied by the installer.
The leveling bolt screws into the radiator and rests
against the floor post to level the radiator.
The 3”x3” base has four mounting holes. The
installer supplies the appropriate mounting bolts to
secure the PED-SM base to the floor.
The PED-SM’s height is fixed to provide 3” clearance
under the radiator, unless otherwise specified.
PED-BM-SQ
The PED-BM-SQ pedestal is used to mount PR2F or
PR3F radiators, up to four tubes tall. Radiators over
four tubes tall should not be mounted on PED-BM-SQ
pedestals, because they will be unstable. Mounting
is accomplished by setting the radiator down over
the fingers of the PED-BM-SQ. The bottom tubes
of the radiator rest on the pedestal, while the fingers
protrude up through the fins to stabilize the radiator.
For Radiators without Fins (on the back side of the
panel) – no wall mounting clips should be ordered for
radiators to be mounted on PED-BM-SQ pedestals.
The 3”x3” base has four mounting holes. The
installer supplies the appropriate mounting bolts to
secure the PED-BM-SQ base to the floor.
The PED-BM-SQ’s height is fixed to provide 3”
clearance under the radiator, unless otherwise
specified.
FIN BKT
ANG BKT
PED-BM-SQ
PED-SM
(PED-BM-SQ)
(PED-SM)
(PR-CLIP)
PR CLIP
