100 mm
50
50
50
Mounting hole
User Manual
You need a torx screwdriver for installation.
Caution!! Install the handle while the enclosure door is open!!! Make a function
check of the handle while the enclosure door is open!!!
Do not close the enclosure door while installing the handle!!!
Install the enclosure door handle as follows:
Prepare the enclosure door by making the openings in the door frame with the
template below (see illustration) (unless already provided because these are
standard openings).
1. At first pull the O-ring to fit the mound of the handle pin.
2. Next, insert the enclosure handle in the mounting hole from
outside (exploded view)
3. Insert the pin in the rod gear.
4. Next, push the seal, then the covers on the handle (as shown in
the exploded drawing.
5. Then tighten 4 screws
Pin for latch, rod gear, etc.
(different lengths)
Press-button
mechanism
DK 7320.950
25
