Rittal Micro Data Center Level E
17
7 Operation
EN
7
Operation
7.1
Handling the doors
Observe the following notes when you open and close
the doors of the Micro Data Center:
7.1.1
Mechanical key lock
Opening the Micro Data Center (DIN right-hand side)
Fig. 2:
Door lock
Turn the lock cover upwards.
Insert the key in the key guide and turn it clockwise.
Turn the handle counter-clockwise until the limit is
reached and open the Micro Data Center door.
Closing the Micro Data Center
Press slowly the Micro Data Center door at the side
opposite the hinges.
Turn the door handle clockwise until it is in the horizon-
tal position.
If the Micro Data Center door is closed too fast, this
produces an air buffer that prevents the Micro Data
Center door from closing.
Turn the inserted key counter-clockwise until the limit
is reached.
Remove the key.
Turn the lock cover downwards.
Danger of becoming trapped
Injuries can occur when the safety doors
are opened or closed.
Ensure that you do not reach between
the door and frame while opening and
closing the doors. Maintain an adequate
safety clearance.
Confinement of persons
The confinement of persons in the not-
fully equipped Micro Data Center can
lead to injuries.
Before closing the not-fully equipped
Micro Data Center, ensure that no per-
sons are still present inside it.
Caution!
There is the danger of tipping when the
doors are opened 180° and the housing
is empty!
Ensure that the Micro Data Center does
not tip. If necessary, secure it to a solid
surface.
Note:
The safety doors of the Micro Data Center
can be opened only to a limited extent. Do
not attempt to force the doors open further
because this would damage the Micro Data
Center.
Note:
Before you close the doors, the safety bolts
must be retracted.
Otherwise the Micro Data Center will be
damaged.
Note:
Before you lock the Micro Data Center, en-
sure that no key is still contained within it (not
even an emergency key)!
The interior of the Micro Data Center must
not be entered! The safety doors do not have
any panic unlocking on the inside.
Note:
Two keys are supplied as standard. All keys
must be retained at a safe place not accessi-
ble to unauthorised persons. If a key is lost,
the lock must be replaced!
Protect the key from dirt accumulation. The
lock must not be oiled or greased.
Note:
After the commissioning of the Micro Data
Center, do not have any keys duplicated by a
key service. If you require additional keys,
please contact the Rittal service department.
If keys get lost, the lock must be replaced
without delay.