Rittal Wiring duct cutter MC 125
15
1 Safety instructions
EN
1
Safety instructions
1.1
Symbols used in these operating instructions
The following symbols are used in this documentation:
This symbol indicates an "action point" and shows that you should perform an
operation or procedure.
1.2
General safety instructions
Always…
– … ensure the cutting device is stable and firmly mounted.
– … check that the blade guard works properly and folds up independently.
– … wear safety goggles, gloves and protective footwear during work.
– … remove chips and cutting waste from blade guard/device.
– … follow the instructions in this operating manual.
– … instruct new operators in the safe use of the cutting device.
– … keep and use in a dry environment.
Never…
– … reach into the cutting area.
– … cut cables or other metal work pieces.
– … use to cut several work pieces at the same time.
– … use the cutting device if damaged or missing parts.
– … work with a dull knife.
– … use if you have not read and understood these operating instructions com-
pletely.
– … expose to corrosive substances.
The device must be completely mounted on a firm and tilt-proof base before op-
erating. The mounting parts are not included. Please use suitable and rugged
mounting parts according to the basis.
The spring-loaded blade guard has to fold up promptly after the cutting proce-
dure. If this feature does not work the knife has to be secured or removed imme-
diately to avoid injuries. Before operating the device again the blade guard has
to be repaired or exchanged.
2
Specified conditions of use
The MC 125 is only to be used to cut plastic wiring ducts and covers up to a
width of 125 mm and a wall thickness up to 2.5 mm. It is only suitable for soft,
non-reinforced plastics.
Warning!
Hazardous situation which may lead to death or serious inju-
ry if the instructions are not followed.
Caution!
Hazardous situation which may lead to (minor) injuries if the
instructions are not followed.
Note:
Identification of situations that can lead to material damage.
