Section 3
Programming
19
Table 5:
Loudmouth
®
Feature Codes
Code
Feature
Default
Description
Special Features
21
Reset to Factory Defaults
Resets Wireless Speaker to Factory default programming.
22
Display Radio Revision
Loudmouth
®
will display a sequence of 6 digits to identify operating
code revision. This is helpful when troubleshooting the radio.
23
Pre-Announce Tone
– On
Enable this feature to play a short tone over the Loudmouth
®
speaker
whenever it receives a signal.
24
Pre-Announce Tone
– Off
Disable Pre-Announce Tone
25
Record and Play
– On
When set received messages are recorded and played back over the
Loudmouth
®
speaker immediately after the received signal is
removed.
26
Record and Play
– Off
Disable Record and Play feature
27
One Speaker
Set when one speaker is used for maximum available volume.
28
Two Speakers
Set when two speakers are used for maximum available volume.
NOTE:
This feature is not required to drive 2 speakers on radios with
firmware 23.05 or higher, or serial number A100119000 or higher.
29
Weather Alert
– On
Enable this feature to receive local NOAA weather radio emergency
broadcasts from the National Weather Service and play them over the
Loudmouth
®
speaker. This feature is only available on the LM-V150.
20
Weather Alert
– Off
Disable Weather Alert
Wideband Operation
(firmware revision 23.05 or higher, or serial number A100119000 or higher)
31
Wideband Operation Enable
When set the Loudmouth
®
is forced into wideband operation,
regardless of programming.
30
Wideband Operation Disable
Loudmouth
®
reverts to the programmed bandwidth. See
Table 1
on
page 16 for the normal table frequency bandwidth.
Battery Powered Operation
41
Battery Operation
– On
Set to extend battery life when powering the Loudmouth
®
with an
external battery.
42
Battery Operation - Off
Set when powering the Loudmouth
®
with the RPS-1B or an external
DC supply.
43
Power Save
– On
Set to enable Power Save operation for battery powered Loudmouth
®
.
This option will have no effect unless Battery Operation
– On is set.
44
Power Save
– Off
Set to disable Power Save operation for RPS-1B powered
Loudmouth
®
.
Relay Operation
(firmware revision 23.05 or higher, or serial number A100119000 or higher)
51
Relay
– On
For radios equipped with a relay, set this option for relay closure when
the Loudmouth
®
receives a valid signal. The relay will remain closed
as long as a signal is received. If Record and Play is enabled, the
relay will close as soon as a signal is received and remain closed
throughout any Record and Play Delay and Recorded Message
Replay.
50
Relay
– Off
Set to disable any relay operation.
Record and Play Operation
(firmware revision 23.05 or higher, or serial number A100119000 or higher)
60
Recorded Message Replay
– 0 times
Recorded messages are repeated concurrently for the number of
61
Recorded Message Replay
– 1 time
times programmed. (Record and Play must be enabled with code 25)
62
Recorded Message Replay
– 2 times
63
Recorded Message Replay
– 3 times
64
Recorded Message Replay
– 4 times
65
Record and Play Delay
– 0 Sec.
Playback of a recorded received message is delayed for the
66
Record and Play Delay
– 5 Sec.
programmed time whenever a valid incoming message is received.
67
Record and Play Delay
– 10 Sec.
If the recorded message is longer than the programmed delay time
68
Record and Play Delay
– 15 Sec.
the message plays back at the conclusion of recording.
69
Record and Play Delay
– 20 Sec.
(Record and Play must be enabled with code 25)
