Section 3
Programming
13
3
Programming
For most installations the Loudmouth
®
can be programmed in the field without the need for
Ritron PC Programmer 12.0.8. Field programming is accomplished in 3 easy steps. First, the
radio frequency and tone codes are entered. Second, the selective signaling code is entered
(if used). Third, the Loudmouth
®
options and volume setting are entered.
3.1
Loudmouth
®
Field Programming Overview
Program
Codes
Table Codes
Enter a 2-digit Frequency code from Table 1
and
a 2-digit QC code from Table 2
or
Enter a 2-digit Frequency code from Table 1
and
a 3-digit DQC code from Table 3.
Enter a 2-digit, 2-Tone Paging code from Table 4
or
Enter any 3
– 7-digit Selcall Paging Code.
Enter a 2-digit Loudmouth
®
Feature code from Table 5 to:
Enable or disable a Pre-Announce Tone.
Enable or disable Record and Play operation.
Set a Record and Play delay time.
Set to repeat a Record and Play message.
Enable or disable Weather Alert feature (VHF models only)
Enable or disable Battery Powered Operation.
Enable or Disable Power Save operation.
Set the Loudmouth
®
for wideband operation.
Enable or Disable Relay operation.
Reset Loudmouth
®
to Factory default programming.
Enter the desired Speaker Volume Level as a 2
–digit number from 05 – 99.
Enter the 1-digit NOAA Weather Frequency code from Table 6 (
VHF models only
)
This only programs the NOAA weather frequency, the Weather Alert feature must be enabled using the Special
Features code in Table 5.
Place the
Loudmouth
®
receiver into
Program
mode.
Use
PROGRAM
button to scroll to
one of the following
Program Code
characters:
[F], [C], [A], [U], [d]
Pause
, a
hyphen
will
appear
on the
display.
Using the
PROGRAM
button,
enter the
desired
Table Code.
Press
ENTER
button to save
programming entry.
Press
ENTER
button a second
time to Exit programming.
or
Proceed with next program entry.
