TRANSMITTER
1.
If the Duplexer required re-tuning, reconnect the RX and TX Phono connections to the RX and TX RF Input
connectors on the Radio Board Assembly.
2. Connect the Repeater Antenna Port to the Full Duplex Input/Output of the Service Monitor. Provisions should be
made to couple the RF output signal to a demodulator, a frequency counter, and an RF wattmeter. The demodulated
output must be viewable on an oscilloscope.
3. Set the Service Monitor to receive the Transmit Frequency of the Repeater, and to generate the Receive Frequency
of the Repeater.
4. C13.8VDC to the DC Input of the Repeater. For the DC Power Jack, the center connection is po) and
the outer sleeve is negative(-).
Summary of Contents for Liberty RLR-460
Page 14: ......
