Ritron JBS-446D, Owner'S Manual

Page: 16 / 32

13 Section 3 Programming
3
Programming
For most installations the Loudmouth
™
can be programmed in the field without the
need for Ritron PC Programmer 12.0.1. Field programming is accomplished in 3
easy steps. First, the radio frequency and tone codes are entered. Second, the
selective signaling code is entered (if used). Third, the Loudmouth
™
options and
volume setting are entered.
3.1
Loudmouth
™
Field Programming Overview
Program
Codes Table
Codes
Enter a 2-digit Frequency code from Table 1 and a 2-digit QC code from Table 2 or
Enter a 2-digit Frequency code from Table 1 and a 3-digit DQC code from Table 3.
Enter a 2-digit, 2-Tone Paging code from Table 4 or
Enter any 3 – 7-digit Selcall Paging Code.
Enter a 2-digit Loudmouth
™
Feature code from Table 5 to:
•
Enable or disable a Pre-Announce Tone.
•
Enable or disable Record and Play operation.
•
Enable or disable Weather Alert feature (VHF models only)
•
Enable or disable Battery Powered Operation.
•
Enable or Disable Power Save operation.
•
Reset Loudmouth to Factory default programming.
Enter the desired Speaker Volume Level as a 2 –digit number from 05 – 99.
Enter the 1-digit NOAA Weather Frequency code from Table 6 ( VHF models only )
This only programs the NOAA weather frequency, the Weather Alert feature must be enabled using
the Special Features code in Table 5.
Place the
Loudmouth
receiver
into
Program
mode.
Use PROGRAM
button to scroll to
one of the following
Program Code
characters:
[F], [C], [A], [U], [d]
Pause , a
hyphen
will
appear
on the
display.
Using the
PROGRAM
button,
enter the
desired
Table Code.
Press ENTER button to save
programming entry.
Press ENTER button a second
time to Exit programming.
or
Proceed with next program entry.