5.4
GENERAL TAB PAGE
The General Page is shown below:
The selections are:
A/B Input One or Two Channel
-Determines the function of the A/B pin. This pin can be used to control
the power selection, high or low, for one channel, channel A or it can be used to choose between channel A
and channel B, in which case, the output power is high for both.
Comm Port Baud Rate
-Determines the baud rate for communications between the data device and the
radio modem. This number should match that shown on the Programmer Configuration screen.
Test Pin Input Logic Level (PTT)
-Determines the polarity of the test pin. The test pin is used to put the
radio in transmit in analog/voice mode or to send test patterns in modem mode. This pin has an internal
pullup resistor and thus, assumes a logic high state when not connected. Therefore, active low is the
normal, default setting.
Red LED
-Determines the behavior of the Red LED indicator. The choices are that it can be set to never be
illuminated or illuminated when the radio is transmitting.
CD Output Logic Level
-Determines the polarity of the CD (Carrier Detect) output pin.
Green LED
-Determines the behavior of the Red LED indicator. The choices are for it to never be
illuminated (off), be illuminated whenever the radio is powered (Power On), when the receiver is locked
and receiving (RX Synthesizer Lock), or data/analog information is being received (RX Data). In the latter
mode, the indicator would come on whenever one of two conditions is met, the squelch level (carrier detect
level) is exceeded, even when Squelch is never muted, or when the receive data has detected a valid data
stream.
