1.1
LPA-Series receiver assembly
The LPA-Series receiver is on any time power is applied. The receiver case must be opened to install the
Mounting Bracket or to program the LPA-Series receiver.
Section 1
Getting Started
2
1. Loosen the (4) captive screws in the front corners of the case. These screws are captive to the housing; to
prevent damaging them,
DO NOT
remove the screws from the housing.
2. Separate the case front from the case back.
3.
Install the Mounting Brackets
by inserting the 4 sealed screws included in the Mounting Bracket kit into the
4 pre-drilled holes shown above. Secure the Mounting Brackets to the case using the lockwashers and nuts
included in the Mounting Bracket kit.
4.
Program the LPA-Series
receiver
per the instructions in the Programming section of this manual, leaving the
RPS-1A power supply connected to the radio. Press the
Enter
button twice before re-assembling the case to
be sure the LPA-Series receiver is reset and ready for operation.
5. Carefully position the case front onto the case back. Secure the case halves by tightening the 4 captive
screws in the front corners of the case.
PROGRAMMING
Enter Button
Program Display
Program Button
RJ-11 Program
Cable Connector
DC Power Connector
for RPS-1A
RCA Phono Jacks
For AUX IN and OUT
BNC Antenna Connector
for AFB-1545
Pre-drilled holes for
Mounting Bracket (4 corners)
Captive Plastic Case
Screws (4 corners)
Barrier Strip
For 600
Ω
Balanced Output
Summary of Contents for AIERIT27-150
Page 3: ......
