7
To connect to the device via Wi-Fi for the first time load the device
configuration software to the local PC and then connect to the access
point.
12.
Add radio channel devices to the system using either of the two methods:
In the configuration software (see User Manual on www.ritm.ru/en);
Using a jumper. To add devices, close the connector JMP1 with a jumper.
Indication on the sensor indicates that a new device has been added to the
system. After you have added a device, open the JMP1 connector (remove the
jumper).
13.
For more information on radio channel operating modes, please refer to device data
sheets.
14.
If data links are not configured, the device operates on a SIM card that was first able
to register on the network (for communication with the device over the CSD channel
during remote configuration).
15.
Make sure the tamper spring is installed and close the device cover.
16.
For information on using of the device in the GEO.RITM mobile and fixed object
monitoring system and its configuration using an object card, please see the Contact
GSM-14 operation manual.
9.
Control from your mobile device
The device supports remote control of areas (removal and arming) with the application
Ritm Control
2
. Control is done using user codes that are defined in the program settings.
10.
Hardware Reset of The Access Point
To reset access point settings to the factory default value,
successively
install JMP3,
and then JMP2.
The network will be reset to the open
«RITM-
last 8 digits of IMEI
».
11.
Maintenance and Safety Measures
At least once per month check SIM card accounts for funds.
All setup and maintenance activities applied to the device should be performed by duly
qualified personnel.
12.
Transportation and Storage
The device should be transported in packaging in closed vehicles. Storage premises
should be free of current-conducting dust, acid and alkaline fumes, corrosive gases and
gases harmful to insulation.
2
The app is available in Google Play. For sharing, the device and the mobile device must be on the
same subnet.
