RITM OKB ZAO SCENAR Basic, Operating Manual

Page: 19 / 35

Operating Manual Version 6.3-04 of 10.10.18
19
When the dose is reached, all the LEDs flash on shortly and a two-
tone beep sounds.
(Optional) The ‘D2’ mode is intended for searching skin areas with
maximal reaction in a labile mode. If the current reaction exceeds the pre-
vious maximum, this is indicated by a
clicking sound . The current reac-
tion to the initial reaction ratio is indicated by LEDs flashing on:
The current to the
initial reaction ratio
Indication
Ratio < ½ All LEDs are switched off
½ <= Ratio < 1
LED
‘D’
lights up
1 <= Ratio < 1½ LEDs
‘D’
and
‘Am’
light up
1½ <= Ratio < 2
LEDs
‘D’, ‘Am’
and
‘Fm’
light up and the
device emits a single beep every second
2 <= Ratio
LEDs ‘
D
’, ‘ Am’ , ‘
Fm
’ and ‘F’
light up and
the device emits double beep every second
ATTENTION! In fact there is a double indication: a relative val-
ue of current reaction to initial one – by LEDs and sounds, and an
absolute maximum of reaction – by clicks .
4.2.7 To set the AM mode, press the
‘ ’
button (sequence of single
taps) until the
‘Am’
LED starts blinking. While the
‘Am’
LED is blinking,
press the
‘ ’
button to switch the mode on, and press the
‘ ’
button to
switch the mode off. The mode switching on is accompanied by an ascend-
ing two-tone beep, the switching off – by a descending two-tone beep.
In the Amplitude modulation mode the stimulation is intermittent:
3 sec – stimulation, 1 sec – pause. The
‘ ’
LED brightness is changing.
4.2.8 To set the FM mode press the
‘ ’
button (sequence of single
taps) until the
‘Fm’
LED starts blinking. While the
‘Fm’
LED is blinking,
press the ‘
’
button to switch the mode on, and press the ‘
’
button to
switch the mode off. The mode switching on is accompanied by an ascend-
ing two-tone beep, the mode switching off – by a descending two-tone beep.
In the Frequency modulation mode the stimulation frequency is con-
tinuously changing from 30 to 120 Hz and back. The
‘ ’
LED brightness
is changing depending on the pulse frequency.
4.2.9 To select one of four stimulation frequencies (14, 60, 90 or
340 Hz), press the
‘ ’
button (sequence of single taps) until the
‘F’
LED
starts blinking. To select a frequency press the
‘ ’
or
‘ ’
button (se-
quence of single taps) while the
‘F’
LED is blinking. The frequency selec-
tion is accompanied by short beeps:

14 Hz – one beep;

60 Hz – two beeps;