Service Manual
13
1. FRONT GRILLE
1. Disconnect the unit from source of power.
2. Using a screwdriver, remove the screw from the front
grille. (See Figure 13)
3. Push the front grille up from the bottom.
Pull the top of the front grille away from the cabinet as the
top tabs lift out of their slots. (See Figure 14)
4. Replace the grille by placing the tabs in the slots and
push the grille until it snaps into place.
2. CABINET
1. Disconnect the unit from the power source.
2. Remove the front grille. (Refer to section 1)
3. Remove 10 screws that secure the cabinet to the base
pan and condenser. (See Figure 15)
4. Lift the cabinet from the unit.
5. Re-install by referring to the procedures above.
3. CONTROL PANEL
1. Disconnect the unit from the power source.
2. Remove the front grille. (Refer to Section 1)
3. Remove the cabinet. (Refer to Section 2)
4. Remove 2 screws that secure the control panel to control
box and base pan. (See Figure 16)
5. Pull the control board toward yourself.
Controls, wires, and capacitor are now accessi-
ble for servicing. Discharge the capacitor before
servicing.
6. Disconnect one housing terminal and 3 wires for the fan
motor and compressor. (See Figure 17)
7. Re-install components by referring to procedures above.
(Refer to wiring diagram on page 19 in this manual or on
control box.)
NOTICE
Disassembly
Disassembly
Figure 13
Figure 14
Figure 15
Figure 16
Figure 17
Mechanical Parts
