10
Publication:
AMEN00395 2020-07-06
10
PUB. NO. FLSFLDG SEPTEMBER 2015
1. Locate the 4” [102] wide black painted steel strip(s)
(A) and place them on the bottom of the curtain
container so the seams fall onto a brace,
Figure
10.1.
2. Raise the header approximately 3’-4’ [914-1219] off
the floor.
3. Locate and unroll the curtain with windbars pre-
installed in front of the unit with the hook/loop
fasteners toward the unit and the ABS pressure
strips away from the unit.
4. If the unit is equipped without a reversing edge,
wrap (B) the curtain around the header and fasten
with the hook/loop fastener,
Figure 10.2.
5. If the unit is equipped with a reversing edge, hook &
loop fasten the curtain to each side of the header,
Figure 10.5.
6. Place the bottom of the curtain into the bottom of
the curtain container and tek screw the ABS strip,
and the steel strip at the bottom braces on the
frame of the curtain container with the #12-14 x 3/4”
[19] self tap/drill screws provided,
Figure 10.3.
7. If optional curtain guides are equipped, they are
fastened with 1/4-20 x 3/4” [6x19] bolts and “T” nuts
(C) to all holes on curtain guide to all (4) pieces.
They are installed by lifting to the top of the
sideframe and slid into the groove. Leave a 1/8” [3]
gap between the end of the curtain guide and the
top of the curtain container to allow for the front and
rear cover installation. If overhead clearance is not
available, the unit may need to be tipped down to
gain access,
Figure 10.4.
FLASHFOLD
™
MODEL FLSFLD
CHAPTER 3 - CURTAIN INSTALLATION
Figure 10.2
Figure 10.3
Figure 10.4
Figure 10.1
A
B
C
