Riso MH 9350, User Manual

Page: 183 / 218

Chapter 11 Troubleshooting
181
11
Example of message
The following provides a typical example of a message.
For anything that are not included in the following list, take an action according to the displayed message.
■
T00-0000: Service call error
■ A00-0000: Master jam error
Code Message Action
T25 !!Battery Replacement!!
Call Service Consult your dealer or authorized service representative and replace
the battery.
Press the [RESET] key to clear the error message.
Code Message Action
A01 Master Mis-Feed
Pull Out
Master Making Unit
and Rewind Master Roll,
then Reset Master
in Place Pull out the master making unit, and then set a master roll in place cor-
rectly.
(
A
165 “Setting the Master Roll”)
B
If the rewound master roll is wrinkled or cut in a zig-zag
manner, cut off the end of the master roll by using a cut-
ter, etc., and then set it in place.
A02 Master Loading Error
Pull Out Print Drum 1
and Discard Master
1
Pull out print drum (cylinder) 1, and then remove the master on the
print drum (cylinder).
(
A
171 “Replacing the Print Drum (Cylinder)”)
2
Set the print drum (cylinder) in place again.
3
Press the [START] key.
A04 Master Disposal Error
Pull Out Print Drum 1
and Discard Master
A05 Master Jammed
in Disposal Unit
Pull Out
Master Disposal Box 1
and Remove
Jammed Master Take out master disposal box 1, and then remove the jammed master.
(
A
170 “Emptying the Master Disposal Box”)
If the error display does not disappear, consult your dealer or autho-
rized service representative.
A06 Set SW
on Standard Feed Tray
is Activated
Reset paper
on Standard Feed Tray Check for any obstacles under the paper feed tray or on the paper.
If there are any obstacles, remove them.
A16 Master Remains
on Print Drum 1
Pull Out Print Drum 1
and Remove Master
1
Pull out print drum (cylinder) 1, and then remove the master on the
print drum (cylinder).
(
A
171 “Replacing the Print Drum (Cylinder)”)
2
Set the print drum (cylinder) in place again.
3
Press the [START] key.
A17 System Error
in Master Making Unit
Take Out Master
and then Close
Master Making-
Unit Cover The cutter that cuts the master roll did not function properly.
1
Pull out the master making unit, and then remove the master roll.
(
A
165 “Setting the Master Roll”)
2
Close the master making unit cover to clear the error.
3
Open the master making unit cover again, and then set the master
roll in place.
A34 Master Not Set in Place
Insert Lead Edge
of Master into Master
Entrance and Close
Master Making Unit Set the master roll in place correctly.
(
A
165 “Setting the Master Roll”)
B
If the rewound master roll is wrinkled or cut in a zig-zag
manner, cut off the end of the master roll by using a cut-
ter, etc., and then set it in place.