Riso MH 9350, User Manual

Page: 172 / 218

Chapter 9 Replacing Consumables
170
Emptying the Master Disposal
Box
This machine is equipped with two master disposal
boxes for print drums (cylinders) 1 and 2. The operat-
ing procedures are the same for both boxes. This sec-
tion describes the procedures in the case of the
master disposal box for print drum (cylinder) 1.
1
Unlock the master disposal box.
If the master disposal box is locked, slide the
lock lever to the right to unlock it.
(This operation is not necessary if the lock han-
dle is not attached.)
2
Remove the master disposal box.
Pull out the master disposal box horizontally
while grasping the master disposal box handle.
3
Dispose of the used masters.
Tilt the master disposal box to the front above a
garbage box.
Grasping the push-out handle drops the used
masters.
Used masters are sent to the master disposal box.
When the master disposal box becomes full, a mes-
sage is displayed and this machine stops.
Dispose of the used masters.
B
Keep the power on while emptying the
master disposal box.
Wash immediately with soap if you get ink on your
hands, etc.
B
When [Protect] (
A
155) is set to on, you
can remove the master disposal box only
when the following message is displayed.
C
[Master Disposal Box is Full]
C
[Master Jammed in Disposal Unit]
Caution
Master disposal box for print drum (cylinder) 1
Master disposal box for print drum (cylinder) 2
B
If a padlock is attached to the mas-
ter disposal box, contact your
administrator and unlock it.
Unlock
Master disposal box handle
Push-out lever