Engineer Programming
Page 60
Using the Engineer Programming Menus
Engineer Programming Menu Conventions
The following typographical conventions are used throughout this chapter:
1.
Numeric keys are represented as
unless they are the final keys in a
programming sequence, in which case they are represented as
2.
Screen text is presented in
déjà vu sans mono
font:
System:
1)Timers
Notes:
If the Authorize Engineer system bit is defined as YES, a Grand Master code is required to
authorize the engineer to enter the programming mode. In this case the grand master code
should be entered after the engineer code via the grand master menu
Quick key menu options are displayed only for system-recognized modules. For non-
recognized modules, your menu option numerical display listing will be non-successive.
The engineer menu consists of the following options:
System, page 61
Zones, page 84
Outputs, page 110
Codes, page 121
Communication, page 126
Audio, page 156
Install, page 160
Devices, page 176
Exit, page
The column headings appear as follows:
Column Heading
Description
Quick Keys
A shortcut to program an option. The shortcuts are listed
in numerical sequence.
Parameter
The name of the option programmed by the selection.
Default
The factory default. The default values have been
carefully chosen and are suitable for most installations.
Range
Where applicable, the range of possible values.
To program the system using Quick Keys:
1.
Access the Engineer Programming menu and select the main menu option that
you want to access.
2.
Press the Quick Keys listed in sequence (from left to right) to locate the option
listed in the Parameter column and then press
.
